Ceiling & Bath Fans in Madison, WI
Ceiling fans installed and balanced, and bath fans replaced so steam actually leaves the room instead of soaking into your walls.
A bathroom fan that no longer clears steam is more than an annoyance — it's the reason paint starts peeling, caulk mildews, and drywall grows soft near the shower. Wisconsin's long heating season means bathrooms stay closed and humid for months, so a working bath fan matters more here than in most places. We replace tired, noisy units with quiet fans that move real air, and we check that the vent path actually reaches outside instead of dumping moisture into the attic.
Ceiling fans get the same careful treatment. A wobbly or clicking fan is often a balance or hardware issue we can settle in one visit, and when you're ready for a new one we mount it solidly — paying attention to what's above the ceiling, since many Madison-area homes have plaster that needs a little extra care.
What Fan Service Covers
Ceiling Fan Installation
Mount and balance a new fan so it runs quietly and safely on a solid box.
Ceiling Fan Repair
Balance wobbly blades, tighten hardware, and quiet clicking or rattling fans.
Bath Fan Replacement
Swap a noisy or weak bathroom fan for a quiet unit that clears steam.
Vent Path Check
Confirm the bath fan duct reaches outside rather than venting into the attic.
Grille & Housing Cleanup
Clear dust-clogged grilles and housings that choke airflow.
Moisture Control
Help protect paint, caulk, and drywall by moving humid air out of the room.
How a Fan Install or Repair Unfolds
Send a photo of the fan or the spot
A picture of the existing fan or the ceiling where you'd like one, with a note on the problem, is usually enough for an initial estimate by phone or email.
Talk through the ceiling above
We discuss what's overhead — plaster or drywall, attic access, and whether there's a fan-rated box — so the mount is solid before we start.
Protect the floor and furnishings
We lay down drop cloths and keep dust contained while we work overhead.
Install, replace, or balance
The new fan or bath fan is mounted and connected, or the existing ceiling fan is balanced and tightened until it runs quietly.
Test and clean up
We confirm the fan runs quiet and clears air the way it should, check the vent path, and leave the room clean.
Good to Know About Bathroom & Ceiling Fans
A weak bath fan lets moisture win. When steam lingers, paint peels, caulk mildews, and drywall softens. A quiet fan that actually moves air is one of the cheapest ways to protect a bathroom.
The vent path matters as much as the fan. A new fan won't help if the duct is disconnected or dumps into the attic. We check where the air is going, not just how loud the motor is.
Plaster ceilings need a careful mount. Older Madison homes with plaster and lath call for a fan-rated box installed with care so the ceiling stays solid and the finish stays clean.
First Time Clients Discount
$50 off with 4 hours of service, or $100 off with 8 hours of service.
Ask about our senior discounts for Dane County homeowners.
Offer valid for first time clients only. One discount per client.
Frequently Asked Questions
Can you replace a noisy or weak bathroom fan?+
Yes. A bath fan that rattles, hums, or no longer clears steam is a common swap. We remove the old unit, connect the new one to the existing housing and duct path where possible, and make sure it vents the way it should.
Do you install ceiling fans where there isn't one yet?+
We can install a ceiling fan where a suitable box is present or can be added. We'll talk through what's above the ceiling — especially in older Madison homes with plaster — before the work starts so the mount is solid and safe.
Why does my bathroom fan seem to do nothing?+
Often the fan motor is tired, the duct is disconnected or kinked, or the grille is clogged with dust. Replacing the fan and checking the vent path usually restores real airflow.
Can you fix a ceiling fan that wobbles or clicks?+
Yes. Wobble usually means the blades are unbalanced or the mount has loosened, and a click often points to a loose blade arm or canopy. We balance the blades, tighten the hardware, and quiet the unit.
How is fan work estimated?+
A photo of the existing fan or the spot where you'd like one, plus a note on the problem, is usually enough for an initial estimate by phone or email. We may ask about the ceiling type and whether there's an attic or floor above.
Serving Dane County Homeowners
Residential service across Madison and the surrounding communities. Find your town:
View all 18 Dane County communitiesWhere We Work in Dane County
We're a residential-only service-area business based in Madison, WI. Pan and zoom the map to explore the communities we serve across Dane County.
Interactive Service Area Map
Loading the map of Madison, WI — Handyman Home Services service area.
Serving Madison & Dane County, WIGet Your Estimate
Send a few details and photos - most jobs can be estimated without a visit.